The Wire: VITEK High Performance Series spark plug wires are a 8.5mm diameter wire constructed with the best components available. The wire begins with a new combination nylon/Kevlar conductor impregnated with ferrite, wound with a copper/nickel alloy metal. The nylon/Kevlar combination in the conductor increases the pull-off strength an additional 10-15 lbs. The low 25 ohm reactive core conductor is the lowest available. The jacket of the wire is a low specific gravity silicone that will withstand up to 500º F. Low specific gravity (while more expensive) increases the "tear" strength of the jacket and the insulating properties. Low specific gravity means less foreign material is mixed in the silicon. Very few, if any, ignition wire manufacturers use this material because of the cost.

The low resistance Vitek High Performance wires are also triple insulated which allows the user to run ignition upgrades as well as audio upgrades without experiencing engine noise through the stereo amplifiers and speakers. Vitek Performance Series ignition wires are rated at 25 ohms per foot. The wire comes in Bright Red with Silver Vitek insignia printed on the wire.

Terminals: All terminals, except where brass is required on the distributor end, are stainless steel snap lock terminals for a more snug fit. Brass terminals are machine bent everywhere a bent terminal is required.

The Boots : All boots at the spark plug side and distributor side are silicone. All phenolic tubes are batch tested for dielectric strength - must exceed 50,000 volts to pass the test or the batch is rejected.

WARRANTY: High Performance Series wire sets are guaranteed to the original consumer purchaser for the life of the vehicle on which they were originally installed. Refer to the package for specific details. The enclosed warranty card must be filled out and returned within 30 days the original purchase date (See wire warranty information).